← All notes & connection map

Preliminary Design

Created on: 2024-12-01
Tags: #preliminaryDesign
Course: AVD


Definition

The three fundamental aircraft parameters are determined during the preliminary design phase

  • Aircraft maximum take-off weight (MTOW)
  • Wing reference area (S)
  • Engine thrust (T) or power (P)

Aircraft parameters such as $C_{D_{0}}$ and $C_{L,Max}$ are also estimated.

Maximum take-off weight estimation

  • First estimation of the aircraft weight
  • Data of past aircrafts with similar configuration and mission is used to estimate the aircraft weight.
  • The maximum take-off weight of the aircraft is broken as

\(W_{TO} = W_{PL} + W_{C} + W_{F} + W_{E}\) Where,

  • $W_{PL}$ is the payload weight.
  • $W_{C}$ is the crew weight.
  • $W_{F}$ is the fuel weight.
  • $W_{E}$ is the empty weight.

$W_{PL}$ and $W_{C}$ are known from mission requirements and standards. $W_{E}$ and $W_{F}$ are expressed as a function of MTOW.

\[W_{TO} = W_{PL} + W_{C} + \left( \frac{W_{F}}{W_{TO}} \right)\, W_{TO} + \left( \frac{W_{E}}{W_{TO}} \right)\,W_{TO}\] \[\implies W_{TO} \left[1 - \left( \frac{W_{F}}{W_{TO}} \right) - \left( \frac{W_{E}}{W_{TO}} \right)\right] = W_{PL} + W_{C}\] \[\implies W_{TO} = \frac{W_{PL} + W_{C}}{\left[1 - \left( \frac{W_{F}}{W_{TO}} \right) - \left( \frac{W_{E}}{W_{TO}} \right)\right]}\]

The empty weight fraction can be estimated from the past aircraft data. \(\frac{W_{E}}{W_{TO}} = a W_{TO} + b\) The fuel weight fraction is dependent on the following,

  • Flight Mission
  • Aerodynamic characteristics of the aircraft
  • Engine SFC

The extra fuel required for safety purposes is almost 5% of the aircraft total weight.

After determination of the weight fractions, solve both equations simultaneously for $W_{TO}$ and $\frac{W_{E}}{W_{TO}}$ .

Wing Area and Engine Sizing

Constraint analysis is used to determine the parameters. The aircraft performance requirements are expressed as Wing loading (W/S) and Thrust-to-weight ratio (T/W) or Power Loading (W/P). Based on the requirements a design point is chosen with highest (W/S) and lowest (W/P).

  • Maximum Speed Requirements (1.2-1.3 $V_{C}$)
  • Stall Speed
  • Maximum rate of climb
  • Take-off run
  • Ceiling
  • Landing run
  • Turn requirements

Linked from