← All notes & connection map

Wing design

Created on: 2024-12-01
Tags: #wingdesign
Course: AVD


Definition

Wing design is the first step of detail design. The wing must produce sufficient lift while generating minimum drag and minimum pitching moment.

Wing reference area (S) is obtained in Preliminary Design. Other parameters are obtained here,

  • Number of wings: 1, 2 or 3
  • Wing location: High, Mid or Low
    • General aircraft and cargo have high wing
    • Passenger aircrafts have low wings
    • Most fighter aircrafts and some GA have mid wing.
  • Airfoil Design
    • Higher $C_{L_{0}}$
    • Lower variation of $C_{L_{i}}$
    • Docile stall qualities
    • Lower $C_{D_{0}}$
    • Higher L/D
    • Lowest $C_{m_{0}}$
    • Ideal lift coefficient obtained from cruise
    • Maximum lift coefficient obtained from stall and use of HLD
  • Wing Incidence
    • AoA at which ideal lift coefficient is generated
    • Drag coefficient is minimum during cruising flight
  • Aspect Ratio
    • Increase in AR , 3 D wing —> 2 D airfoil.
    • Weight increases with AR.
    • L/D increases with AR.
    • Selected based on past aircraft data.
  • Taper Ratio
    • Introduced to obtain elliptical lift distribution and reduce the induced drag.
    • Tip may stall before the root (Undesirable).
    • Increase the cost of wing manufacturing
    • Reduces the weight of the wing.
  • Sweep Angle
    • Angle between a constant chord line and the lateral axis perpendicular to the fuselage centerline.
    • Improve aerodynamic performance at higher flight speeds.
    • Adjusting CG.
    • Improving static stability.
    • Tip stall may produce severe stability issues.
    • Low subsonic aircraft, no sweep recommended.
    • High subsonic and supersonic aircraft, must have sweep.
  • Twist Angle
    • Aerodynamic and geometric twist.
    • Aerodynamic twist more practical and convenient than geometric twist.
    • Twist results in reduction of lift.
    • Done to obtain an elliptic lift distribution.
  • Dihedral Angle
    • Improves lateral stability of the aircraft.
    • Prevents excessive spiral instability, but Dutch-roll becomes instable.
    • For high-wing aircrafts, anhedral is used to reduce the excessive stability.
    • The balance between lateral stability and roll control is a major criterion for the determination of dihedral angle.
    • More stability ==> Less control
  • High Lift Devices
    • To maximize the $C_{L_{max}}$.
    • Leading edge and trailing edge HLD
    • HLD chord, span, maximum deflection, type and location along span depends on the mission and control surfaces.

Linked from